Skip to main content

Wire it up

1

Turntables into the interface

Each turntable goes into its own input pair on the interface. If the interface has a PHONO/LINE switch per input, set it to PHONO for a turntable.
2

Interface into the mixer

Each deck’s output pair goes into a line input on your mixer. The mixer does all the mixing.
3

Open Dub

With the interface plugged in, Dub opens the two-deck Performance surface. A known interface like the Serato SL 3 is routed for you; any other is set up once in Preferences ▸ Audio (see Hardware).

Load a track

  • Drag a track from the library onto a deck.
  • Or select it in the library and press Space: it loads onto the deck that isn’t the master, so the deck you’re playing out of stays untouched.
In Performance, loading never starts playback. The record does that.

The source switch: INT · TC · THRU

Each deck has a three-way switch in its header. You choose the mode; Dub never switches it for you.

Calibration

You don’t need to calibrate by hand. The first time a deck hears a turning control record in a session, it measures the needle by itself: the deck says CALIBRATING while it does, then Calibrated. Keep the record playing at normal speed for a moment. The ↻ button next to the switch recalibrates on demand, after a needle change or a new control record. It works on TC and on INT, so you can recalibrate while the set plays on (see Saving a set on stage).

The signal panel

Each deck has a SIGNAL tab at its outer edge. It opens one word for the state of that deck’s timecode and one line on what to check: The panel also meters each input channel in dB and draws the timecode’s shape: a clean signal is a round circle, a weak channel squashes it.

The output meters

Between the decks, under the phase meter, two slim meters show what each deck is actually sending to the mixer. When a meter is empty for a reason, it says so:
  • ECHO OUT: echo out is still on and its tail has died away. The record plays on underneath, but nothing leaves the deck. Turn echo out off.
  • NO OUTPUT: the deck has no output pair, or the audio engine isn’t running.