Skip to main content

Saving a set on stage

The needle breaks or the control record gives out mid-set. Dub is built so the beat doesn’t stop:
1

Switch the deck to INT

The track keeps playing on Dub’s own clock from exactly where it was. The deck stays on INT until you switch it back; the record can’t take it over by accident.
2

Fix the needle or swap the record

Take your time. The set plays on.
3

Recalibrate while INT plays

Put the needle down on the turning record and press ↻. A lamp in the TC segment shows the record’s state: amber while it measures, green when it’s ready to take the deck back.
4

Switch back to TC

When the lamp is green, press TC. The record picks the track up where INT has it, without a dropped beat.

The needle won’t lock

Open the deck’s SIGNAL panel and read its word:
Nothing is arriving on that deck’s input. Is the needle down and the record turning? Check the interface’s PHONO/LINE switch for that input, and the cable.
One channel is low or the signal is noisy. The panel names the low channel. Check that cable and the needle; a worn or dirty stylus does this too.
Timecode is arriving but isn’t readable right now. That’s normal while you scratch or when the record is stopped.
The deck has no input assigned. Pick one in Preferences ▸ Audio.
If the word is right but the deck still drifts, press ↻ to recalibrate on the record that’s on the platter now.

The fader is up but nothing comes out

Look at the deck’s output meter between the decks:
  • ECHO OUT: echo out is still on, and its tail has died away. The record plays on but nothing leaves the deck. Turn echo out off.
  • NO OUTPUT: the deck has no output pair, or the audio engine isn’t running. Check Preferences ▸ Audio.
  • The meter moves: Dub is sending. Check the mixer channel, its input selector and the cable.

Dub doesn’t know my interface

Dub runs an interface it doesn’t know as one deck on inputs 1–2, and tells you so once. Set its channels in Preferences ▸ Audio; see Setting up your interface.

A sample or Quick Scratch pad says MISSING

The sample’s file was moved or deleted since you put it on the pad. UNREADABLE means the file is there but can’t be decoded. Drop another file on the pad. Pressing a missing pad tells you which file is gone, and a missing Quick Scratch pad won’t park your tune for silence.

A THRU record reads at the wrong tempo

Drum’n’bass on THRU can read at two-thirds of its tempo. Right-click the BPM and choose ×1.5, or tap the tempo.

macOS won’t open Dub

The alpha isn’t notarized by Apple yet. Open System Settings → Privacy & Security, find “Dub” was blocked, and click Open Anyway. See Install Dub.

Still stuck

Open an issue with what you did, what you expected, and which interface and control vinyl you use.